arrow_left

How to make a 2D origami boot of Santa Claus

(page 1)

arrow_right

 

2D origami boot of Santa Claus

 

Level Beginner
Copyright Traditional

This page is for those who want the instruction to fold a 2D origami boot of Santa Claus.

 

This 2D origami boot of Santa Claus is an easy origami model to fold. Although this is 2D model, you can make it stand on the ground. One special folding technique involved with this model is inside reverse-fold.

 

Before working on this model, you need to know what valley-fold and mountain-fold are. If you know these two folding techniques, then you will have no problem in making origami boot.

 

If you are ready, then let's get started.

 

If you find any bugs on this instruction, please send an email to HyoAhn's email.

 

You may use any kind of paper to fold this origami boot. Here I am using a typical origami paper with 15cm x 15cm square.

2D origami boot of Santa Claus: front side of paper

00A.

This is the front side of paper.

 

15cm x 15cm square paper is being used here.

2D origami boot of Santa Claus: back side of paper

00B.

This is the back side of paper.

 

 

left arrow
left arrow

 

1 2 3 4 5 6 7 8 9 10



 

 




How To Make A 2D Origami Boot Of Santa Claus


© 2010-2024 origami-make.org All Rights Reserved