arrow_left

How to make a New Origami Crane

(page 1)

arrow_right

 

origami crane

 

Level Intermediate
Copyright Hyo Ahn

This page is for those who want the instructions to make a New Origami Crane.

 

This origami crane is different from the traditional origami crane. It is based on calyx base instead of bird base. It is a bit skinnier than the traditional one.

 

Before working on this model, you need to know what valley-fold and mountain-fold are. If you know these two folding techniques, then you will have no problem in making origami dragon.

 

If you are ready, then let's get started.

 

If you find any bugs on this instruction, please send an email to HyoAhn's email.

 

You may use any kind of paper to fold the origami dragon. It is a little easier if the front and the back side of the paper are slightly different whether it be in texture or color.

Make sure the paper that you use is a square (all sides are equal and all the angles equal 90 degrees). The paper I am using here is 20cm x 20cm square one. It is a good size for those who are not experienced in paper folding. If you are become familiar with this model. Then you can try smaller size paper.

origami crane: front side of paper

00A.

This is the front side of paper.

origami crane: back side of paper

00B.

This is the back side of paper which is the same color as the front side.

 

Share this page through
Twitter Facebook MySpace Digg Digg Digg
Digg Digg Digg Digg Digg Digg

 

left arrow
left arrow

 

1 2 3 4 5 6 7 8 9 10

11 12 13 14 15 16


 

 

Let's share the photo of "origami crane" you made by submitting it below:
blog comments powered by Disqus


How To Make A New Origami Crane


© 2010-2017 origami-make.org All Rights Reserved