arrow_left

How to make a 3D origami paper cup II

(page 1)

arrow_right

 

3D origami cup II

 

Level Intermediate
Copyright Hyo Ahn

This page is for those who want the instruction to make a 3D origami paper cup II.

 

This 3D origami cup starts from a 8x8 matrix base. One special folding technique you need to apply is inserting a flap under a layer.

 

If you are ready, then let's get started.

 

If you find any bugs on this instruction, please send an email to HyoAhn's email.

 

You may use any kind of paper to fold the origami cup. But if you want to use this cup for drinking water, it would be better to use a waterproof paper. Make sure the paper that you use is a square (all sides are equal and all the angles equal 90 degrees). The paper I am using here is 20cm x 20cm square one.

3D origami paper cup II: front side of paper

00A.

This is the front side of paper.

 

This side becomes the inside of origami cup.

3D origami paper cup II: back side of paper

00B.

This is the back side of paper.

 

This side becomes the outside of origami cup.

 

 

left arrow
left arrow

 

1 2 3 4 5 6 7 8 9 10

11 12 13 14 15 16 17 18 19


 

 

Let's share the photo of "3D origami paper cup II" you made by submitting it below:
blog comments powered by Disqus


How To Make A 3D Origami Paper Cup II


© 2010-2017 origami-make.org All Rights Reserved