arrow_left

How to make a new origami crown (cubed crown)

(page 1)

arrow_right

 

new origami crown

 

Level Beginner
Copyright Hyo Ahn

This page is for those who want the instruction to fold a new origami crown .

 

This new crown model starts from 3x3 matrix base. This new model is similar to the traditional crown model since it hast the same four points. However, this model has more voulme and actually it has the double more volume compare to the traditional one. Since the voulme space is exactly a cube, so it can also be called a "cubed crown". A special folding technique that you would learn from this model is inside reverse-fold.

 

If you are ready, then let's get started.

 

If you find any bugs on this instruction, please send an email to HyoAhn's email.

 

You may use any kind of paper to fold the origami crown. It is a little easier if the front and the back side of the paper are slightly different whether it be in texture or color.

Make sure the paper that you use is a square (all sides are equal and all the angles equal 90 degrees). The paper I am using here is 15cm x 15cm square gold paper to simulate a crown.

 

 

 

 

new origami crown : front side of paper

00A.

This is the front side of paper.

new origami crown : back side of paper

00B.

This is the back side of paper.

 

Share this page through
Twitter Facebook MySpace Digg Digg Digg
Digg Digg Digg Digg Digg Digg

 

left arrow
left arrow

 

1 2 3 4 5 6 7 8 9 10

11 12 13 14 15 16 17 18 19


 

 

Let's share the photo of "new origami crown " you made by submitting it below:
blog comments powered by Disqus


How To Make A New Origami Crown (cubed Crown)


© 2010-2017 origami-make.org All Rights Reserved